Smart Switch PL401

With this Smart Switch you switch any electrical device and application. That can be done using the Jadrimex Smart App, but just as easily with remote controls.

• Managed through the Jadrimex Smart App
• Option to operate it through the Jadrimex Smart App
• Option to operate it with remote controls
• Switching on/off, on and off separately
• Setting a weekly schedule
• Data connection via WIFI 2.4G for use of the Jadrimex Smart App
• If there is no WIFI connection, control it with remote controls
• 220 volt power supply. 12-24 volt is an option
• Maximum throughput current 2200W/10Amp per relay

Installing the Smart Switch is straightforward. Open the top with a Phillips screwdriver. Connection by means of 220 volt. (12-24 volt optional) There are 2 relays available and they can be programmed/set separately. Set up with the Jadrimex Smart App. Operation can take place with the Jadrimex Smart App, but also with remote control(s).

If no wifi connection is available in the area around the switch, it can only be operated by means of remote control(s). These can be assigned to the switch.

If the switch is built in behind steel or concrete, installing an external antenna matters. (available as an option)

Remote control

These remote controls are assigned one by one to the switch in question. One remote control can be programmed to several switching units.

When you press the button on the remote control a red light comes on, so you can see that the signal is being sent.

The range of the remote control is +/- 50 metres if there are no obstructions. An external antenna may need to be installed. (option)

The remote control is powered by 2x 3 volt CR2016 batteries